![]() ![]() the pinwheel and slowness issues went away, as did the errant scans after playing wit the preview levels. Maybe this lead to some caching issues with Epson Scan 2? So, after dinner, I restarted my computer and set up some more negatives to scan. One thing that occurred to me was that I hadn't restarted my computer in the past couple of days, especially since reinstalling Epson Scan 2 (with Macs, restarting the computer when installing new software is rarely required). So, I stepped away from the computer a bit and muddled the issue around in my head. This image was done with the older version of Epson Scan 2 after I adjusted the levels in the preview: The film is either 126 or 127 (I haven't measured) and I am scanning via wet-mount method with the supplied Epson wet-mount tray. These were most likely taken on a Kodak Brownie (or the like), and to be clear I'm not expecting to get Hasselblad-quality scans. (sigh)Īt the moment, I'm scanning some of my grandmother's old negatives from the 50's. Further, I've run into a new problem: After adjusting the histogram in preview, the resulting scanned image is coming out totally out of whack. ![]() Unfortunately, this did not at all resolve my issues. ![]() So I uninstalled the older version of Epson Scan 2 and downloaded/installed the newer version. I did some research on this issue, and it seems that since I downloaded Epson Scan 2 in mid-September, there was an updated driver/program made available in October. I get this, for example, whenever I try to resize a box around an image, play with levels in the histogram, etc. Every action I do now results in a "pinwheel" as the program is "thinking". However, a couple of days ago I upgraded to iOS 12 (Monterey) and right off the bat, I noticed that Epson Scan 2 was having problems. Epson Scan 2 was nowhere near as intuitive, and seemed quite clunky. Right off the bat, as an interface, Epson Scan 2 had a lot to be desired over the original Epson Scan. Unfortunately, with the newer 64-bit iMacs running iOS 11 (Big Sur), this meant that my old Epson Scan software would no longer be working. However, in early September, my iMac crashed, and I needed to get a new one. Long story short, I had been using Epson Scan as the interface between my iMac and Epson Perfection V750 Pro for the past ten years. I've now been working with Epson Scan 2 (as opposed to the original Epson Scan) for the past 2 months or so, and to be quite frank, I'm not very happy with it. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |